Subaru Legacy: Daytime running light system
WARNING
The brightness of the illumination of the high beam headlights is reduced by the daytime running light system. The light switch must always be turned to the “” position when it is dark outside.
The high beam headlights will automatically illuminate at reduced brightness when the engine has started, under the following conditions.
● The parking brake is fully released.
● The light switch is in the “OFF” or “ ” position.
● The light switch is in the “AUTO” position and the headlights do not turn on automatically.
● The select lever is in a position other than the “P” position (AT and CVT models).
NOTE
When the light switch is in the “ ” position, the front side marker lights, tail lights and license plate lights are illuminated.
Headlight flasher
CAUTION Do not hold the lever in the flashing position for more than just a few seconds. To flash the headlights, pull the lever toward you and then release it. The high beam will stay on for as ...Turn signal lever
To activate the right turn signal, push the turn signal lever up. To activate the left turn signal, push the turn signal lever down. When the turn is finished, the lever will return automaticall ...See also:
Tire inflation
Check tire inflation pressure regularly.
See the tire inflation table on page 275. A tire inflation pressure placard is
also located on the driver's side B-pillar (the structural member at the ...
Cruise control operations
The cruise control allows driving at a speed between
25 - 89 MPH (40 - 144 km/h) without
keeping your foot on the accelerator pedal.
To turn on the cruise control, push the
ON·OFF switch. The CRU ...
Head Restraint Adjustment
Do not drive until the head restraints for all occupants are installed and adjusted properly.
To achieve a comfortable seating position, change the seatback recline angle as little as necessary while ...