Chrysler 200: Fluid Level Check – Six-Speed Automatic Transmission
The automatic transmission has no dipstick and is dealer serviced only.
Fluid Level Check – Four-Speed Automatic Transmission
Use the following procedure to check the automatic transmission fluid level properly: 1. Park the vehicle on level ground. 2. Run the engine at curb idle speed for a minimum of 60 seconds. 3. A ...Transmission Fluid And Filter Changes
Refer to the “Maintenance Schedule” for the proper maintenance intervals. In addition, change the fluid and filter if the transmission is disassembled for any reason. ...See also:
Notes for locking the doors
●Touching the door lock sensor while wearing gloves may delay or prevent
lock operation. Remove the gloves and touch the lock sensor again.
●When the lock operation is performed using t ...
Engine immobilizer system
The vehicle's keys have built-in transponder chips that prevent the
engine from starting if a key has not been previously registered in
the vehicle's on-board computer.
Never leave the keys insid ...
ENGINE
OVERHEATED — IDLE
ENGINE
This message displays when the
engine coolant temperature is too
hot. Stop and allow the vehicle to
idle until it cools down. ...