Subaru Legacy: High/low beam change (dimmer) - Light control switch - Instruments and controls - Subaru Legacy Owners ManualSubaru Legacy: High/low beam change (dimmer)

To change from low beam to high beam, push the turn signal lever forward. When

To change from low beam to high beam, push the turn signal lever forward. When the headlights are on high beam, the high beam indicator light “on the combination meter is also on.” on the combination meter is also on.

To switch back to low beam, pull the lever back to the detent position.

    Sensor for the auto on/off headlights
    The sensor is on the instrument panel as shown in the illustration. CAUTION If any object is placed on or near the sensor, the sensor may not detect the level of the ambient light correctly and ...

    Headlight flasher
    CAUTION Do not hold the lever in the flashing position for more than just a few seconds. To flash the headlights, pull the lever toward you and then release it. The high beam will stay on for as ...

    See also:

    Blind Spot Information System*
    Introduction 1 - BLIS camera 2 - Indicator light 3 - BLIS symbol The Blind Spot Information System (BLIS) is an information system that indicates the presence of another vehicle moving in the ...

    Legacy
    A shopping bag hook is attached to each inner side wall of the trunk near the trunk lid opening. ...

    General Information
    For service and parts needs, visit your dealer. You will receive genuine GM parts and GM-trained and supported service people. Genuine GM parts have one of these marks: California Proposit ...