Buick Regal: Power Windows
The power window switches located on the driver door control all four windows. The passenger doors have a window switch that controls that window. Push the switch down to open the window. Pull the front of the switch up to close it.
The switches work when the ignition is in ON/RUN, ACC/ACCESSORY, or in Retained Accessory Power (RAP). See Retained Accessory Power (RAP)
Express Window Operation
Windows with an express-up or down feature allow the front windows to be lowered or raised without holding the switch. Rear windows only have express down.
Pull a window switch up or push it down all the way, release it, and the window goes up or down automatically. Stop the window by pushing or pulling the switch.
Rear Window Lockout with Power Safety Locks
For vehicles with power safety locks, the rear window lockout button is on the driver door. Press to disable the rear window controls and turn on the rear door power safety locks. The light on the button comes on indicating the feature is in use. The rear windows can still be raised or lowered using the driver window switches when the lockout feature is active. To restore power to the rear windows, press the button again. The light on the button goes out. If the light flashes, the feature may not be working properly.
Rear Window Lockout without Power Safety Locks
For vehicles without power safety locks, the rear window lockout switch is on the driver door. This feature prevents the rear passenger windows from operating, except from the driver position.
Press to activate the rear
window lockout switch. A LED comes on when activated.
Press again to deactivate the lockout switch.
If the LED flashes, the feature may not be working properly.
Programming the Power Windows
If the battery on the vehicle has been recharged, disconnected, or is not working, you will need to reprogram each front power window for the express-up feature to work.
Before reprogramming, replace or recharge the vehicle's battery.
To program each front window, follow these steps:
1. With the ignition in ACC/ ACCESSORY or ON/RUN, or when Retained Accessory Power (RAP) is active.
2. Press and hold the power window switch until the window is fully open.
3. Pull the power window switch up until the window is fully closed.
4. Continue holding the switch up for approximately two seconds after the window is completely closed.
The window is now reprogrammed.
Repeat the process for the other windows.
Windows
WARNING
Leaving children, helpless adults, or pets in a vehicle with the windows closed is dangerous.
They can be overcome by the extreme heat and suffer permanent injuries or even death from hea ...
Sun Visors
Pull the sun visor down to block glare. Detach the sun visor from the center mount to pivot to the side window, or to extend along the rod, if available. ...
See also:
Programming HomeLink for Canadian customers
Prior to 1992, D.O.C. regulations required handheld transmitters to stop transmitting
after 2 seconds.
To program your hand-held transmitter to HomeLink, continue to press and hold
the HomeLink b ...
Contacts
Note
If equipped with full mobile phone preparation
package.
At a glance
Contacts can be created and edited. The contacts
from the mobile phone are displayed as
well if this function is suppo ...
Winter (snow) tires
Winter tires are best suited for driving on snow-covered and icy roads. However
winter tires do not perform as well as summer tires and all season tires on roads
other than snow-covered and icy ro ...