BMW 5 Series: Reassigning individual programs - Integrated universal remote 
control - Interior equipment - Controls - BMW 5 Series Owners ManualsBMW 5 Series: Reassigning individual programs

1. Switch on the ignition.
2. Hold the hand-held transmitter a distance of approx. 1 to 3 in/2.5 to 8 cm from the memory buttons.
The required distance depends on the manual transmitter.
3. Hold down the memory button of the integrated universal remote control.
4. If the LED flashes slowly after approx.

20 seconds, press the transmit button on the hand-held transmitter.
5. Release both buttons when the LED flashes rapidly.
If the LED does not flash rapidly after approx.
60 seconds, change the distance and repeat the step.
Canada: if the LED is not flashing rapidly after approx. 60 seconds, change the distance and repeat the step, or, if the programming was interrupted by the hand-held transmitter, hold down the memory button and press and release the button on the hand-held transmitter again for 2 seconds.

    Programming
    ▷ LED, arrow 1. ▷ Memory buttons, arrow 2. Fixed-code hand-held transmitters 1. Switch on the ignition. 2. Initial setup: Press the two outer memory buttons 1 and 3 for approx. 20 ...

    Deleting all stored programs
    Press the two outer memory buttons for approx. 20 seconds until the LED flashes rapidly. All stored programs are deleted. The programs cannot be deleted individually ...

    See also:

    How to Minimize Environmental Paint Damage
    The paintwork on your Mazda represents the latest technical developments in composition and methods of application. Environmental hazards, however, can harm the paint's protective properties, i ...

    Removing covers from rear parcel shelf
    Remove the top tether anchor cover or key cylinder cover as follows: 1. Lift the cover to the full open position. 2. Rotate the cover in the direction shown, disengaging the hinge at 1 and sli ...

    Installing covers to rear parcel shelf
    CAUTION Make sure that the hinge is completely aligned with the pin. If the pin is forced into position, it may break. Install the top tether anchor cover or key cylinder cover as follows: 1. ...