Buick Regal: Ride Control System Messages - Vehicle Messages - Instruments and Controls - Buick Regal Owners ManualBuick Regal: Ride Control System Messages

SERVICE TRACTION CONTROL

This message displays when there is a problem with the Traction Control System (TCS). When this message is displayed, the system will not limit wheel spin. Adjust your driving accordingly. See your dealer for service.

SERVICE STABILITRAK

This message displays if there is a problem with the StabiliTrak® system. If this message appears, try to reset the system. Stop; turn off the engine for at least 15 seconds; then start the engine again. If this message still comes on, it means there is a problem. See your dealer for service. The vehicle is safe to drive; however, you do not have the benefit of StabiliTrak, so reduce your speed and drive accordingly.

SPORT MODE ON

This message displays when using the interactive drive control. See Interactive Drive Control System  for more information.

TRACTION CONTROL OF

This message displays when the Traction Control System (TCS) is turned off. Adjust your driving accordingly.

TRACTION CONTROL ON

This message displays when the Traction Control System (TCS) is turned on.

    Object Detection System Messages
    PARK ASSIST OFF This message is displayed when the park assist system has been turned off. See Ultrasonic Parking Assist . SERVICE PARK ASSIST This message is displayed if there is a problem with ...

    Anti-theft Alarm System Messages
    THEFT ATTEMPTED This message displays if the vehicle detects a tamper condition. ...

    See also:

    Locking doors
    Locking doors 1. Move the shift selector to the P (Park) position, place the ignition switch in the LOCK position and make sure you carry the Intelligent Key with you. 2. Close all doors. 3. Pus ...

    Adding Coolant
    Your vehicle has been built with an improved engine coolant (antifreeze) that allows extended maintenance intervals. This engine coolant (antifreeze) can be used up to five years or 104,000 mile ...

    High-beam flasher
    •► To switch on: turn the SmartKey in the ignition lock to position 1 or 2 or start the engine. •► Pull the combination switch in the direction of arrow 3. ...