Buick Regal: Safety Belt Reminders
Driver Safety Belt Reminder Light
There is a driver safety belt reminder light on the instrument panel cluster.
When the engine is started this light begins to flash and a chime comes on for several seconds to remind the driver to fasten their safety belt.
The light also stays on if the driver remains unbuckled.
This cycle repeats if the driver is unbuckled while the vehicle is moving.
If the driver safety belt is already buckled, neither the light nor the chime comes on.
Passenger Safety Belt Reminder Light
There is a passenger safety belt reminder light located on the center console.
When the engine is started this light begins to flash and a chime comes on for several seconds to remind the passenger to fasten their safety belt. The light also stays on if the passenger remains unbuckled.
This cycle repeats if the passenger is unbuckled while the vehicle is moving.
If the passenger safety belt is buckled, neither the chime nor the light comes on.
The front passenger safety belt warning light and chime may turn on if an object is put on the seat such as a briefcase, handbag, grocery bag, laptop, or other electronic device. To turn off the warning light and/or chime, remove the object from the seat or buckle the safety belt.
Engine Coolant Temperature Gauge
Metric English This gauge shows the engine coolant temperature. If the indicator needle moves to the hot side of the gauge toward the shaded area, the engine is too hot. If the vehicle has been ...Airbag Readiness Light
This light shows if there is an electrical problem. The system check includes the airbag sensor, the pretensioners, the airbag modules, the wiring, and the crash sensing and diagnostic module. For mo ...See also:
Lane Change Assist
Tap the lever up or down once, without moving beyond
the detent, and the turn signal (right or left) will flash
three times then automatically turn off. ...
Radio AM
To switch to the AM band, say “AM” or “Radio AM”. In
this mode, you may say the following commands:
• “Frequency #” (to change the frequency)
• “Next Station” (to select the ...
Door Latches
Check for positive closing, latching, and locking. ...