Buick Regal: Transferring a Call
Audio can be transferred between the in-vehicle Bluetooth system and the cell phone.
To Transfer Audio to the Cell Phone
During a call with the audio in the vehicle:
1. Press . The system responds “Ready,” followed by a tone.
2. Say “Transfer Call.” The system responds “Transferring call” and the audio transfers to the cell phone.
To Transfer Audio to the In-Vehicle Bluetooth System
The cell phone must be paired and connected with the Bluetooth system before a call can be transferred. The connection process can take up to two minutes after the ignition is turned to ON/RUN or ACC/ACCESSORY.
For vehicles without a navigation system, press b / g during a call with the audio on the cell phone.
The audio transfers to the vehicle.
For vehicles with a navigation system, press b / g during a call with the audio on the cell phone.
If the audio does not transfer to the vehicle, use the audio transfer feature on the cell phone. See the cell phone manufacturer's user guide for more information.
Muting a Call
During a call, all sounds from inside the vehicle can be muted so that the person on the other end of the call cannot hear them. To Mute a call 1. Press . The system responds “Ready,” followe ...Voice Pass-Thru
Voice pass-thru allows access to the voice recognition commands on the cell phone. See the cell phone manufacturer's user guide to see if the cell phone supports this feature. To access contacts stor ...See also:
USB Flash Memory Device Error Messages
If you see an error message on the
audio display while playing a USB
flash memory device, find the
solution in the chart to the right. If
you cannot clear the error message,
take your vehicl ...
Electronic speed control
When engaged, the Electronic Speed Control takes overthe accelerator operation
at speeds greater than 25 mph(40 km/h).
The Electronic Speed Control lever is located on the rightside of the steering ...
For the 530i, 535i, 550i, 525d,
530d and 535d: check oil level
The concept
The oil level is monitored electronically and displayed
on the Control Display.
Requirements
▷ The engine must be running and warm after
the vehicle has been driven for at lea ...