Buick Regal: Turn and Lane-Change Signals
Move the lever all the way up or down to signal a turn.
An arrow on the instrument panel cluster flashes in the direction of the turn or lane change.
Raise or lower the lever until the arrow starts to flash to signal a lane change. Hold it there until the lane change is completed. If the lever is briefly pressed and released, the turn signal flashes three times.
The turn and lane-change signal can be turned off manually by moving the lever back to its original position.
If after signaling a turn or lane change, the arrow flashes rapidly or does not come on, a signal bulb might be burned out.
Have the bulbs replaced. If the bulb is not burned out, check the fuse.
See Fuses and Circuit Breakers .
Hazard Warning Flashers
Hazard Warning Flasher: Press this button located on the instrument panel above the audio system, to make the front and rear turn signal lamps flash on and off.
Press again to turn the flashe ...
Fog Lamps
To turn on the fog lamps, the ignition and the headlamps or parking lamps must be on.
If the fog lamps are turned on while the exterior lamp switch is in the AUTO position, the headlamps come on ...
See also:
Using the telephone - Vehicles Without: Navigation System
This chapter describes the phonefunctions of the audio unit.
Note: Refer to your audio guide fordetails of the controls.
An active phone must be present.
Even if connected to the audio unit, yourph ...
Vanity mirrors (if so equipped)
Coupe shown, sedan similar
To access the vanity mirror, pull the sun visor
down and flip open the mirror cover. Some vanity
mirrors are illuminated and turn on when the
mirror cover is open. ...
Safety Belt Extender
If the vehicle's safety belt will fasten around you, you should use it.
But if a safety belt is not long enough, your dealer will order you an extender. When you go in to order it, take the heaviest ...