Buick Regal: Washer Fluid
What to Use
When windshield washer fluid is needed, be sure to read the manufacturer's instructions before use. If operating the vehicle in an area where the temperature may fall below freezing, use a fluid that has sufficient protection against freezing.
Adding Washer Fluid
Open the cap with the washer symbol on it. Add washer fluid until the tank is full. See Engine Compartment Overview for reservoir location
Notice . When using concentrated washer fluid, follow the manufacturer's instructions for adding water.
► Do not mix water with ready-to-use washer fluid.Water can cause the solution to freeze and damage the washer fluid tank and other parts of the washer system.
Also, water does not clean as well as washer fluid.
► Fill the washer fluid tank only three-quarters full when it is very cold. This allows for fluid expansion if freezing occurs, which could damage the tank if it is completely full. ► Do not use engine coolant (antifreeze) in the windshield washer. It can damage the windshield washer system and paint.
Power Steering Fluid
See Engine Compartment Overview for reservoir location.
When to Check Power Steering Fluid
It is not necessary to regularly check power steering fluid unless a leak is suspected in the syste ...
Brakes
This vehicle has disc brakes. Disc brake pads have built-in wear indicators that make a high-pitched warning sound when the brake pads are worn and new pads are needed.
The sound can come and go or b ...
See also:
Airbag System Check
The airbag system does not need
regularly scheduled maintenance or
replacement. Make sure the airbag
readiness light is working. See
Airbag Readiness Light for more information.
Notice:
If a ...
Seat belt height adjustment
Seat belt height adjustment
Note: Lifting the slider slightly whilepressing the locking button makes iteasier to release the locking mechanism.
To raise or lower, press the locking buttonon the adju ...
MODE button
This button is used to select the desired audio mode. Each time it is pressed,
the mode changes to the next one in the following sequence.
*1: The frequency last received in the selected waveba ...