Subaru Legacy: Windshield washer
To wash the windshield, pull the wiper control lever toward you. The washer fluid sprays until you release the lever. The wipers operate while you pull the lever.
NOTE
The windshield washer fluid warning light illuminates when the washer fluid level in the tank has dropped to the lower limit. If the warning light illuminates, refill the tank with fluid. For the tank refilling method, refer to “Windshield washer fluid” F11-40.
Wiper intermittent time control
When the wiper switch is in the “INT” position, turn the dial to adjust the operating interval of the wiper. The operating interval can be adjusted in five steps from the shortest interval t ...Rear window wiper and washer switch (Outback)
: Washer (accompanied by wiper operation) ON: Continuous INT: Intermittent OFF: Off : Washer (accompanied by wiper operation) ...See also:
Hazard Warning Flashers
Hazard Warning Flasher: Press this button located on the instrument panel above the audio system, to make the front and rear turn signal lamps flash on and off.
Press again to turn the flashe ...
Selector lever
Overview of transmission positions
Selector lever in AMG vehicles with P button
P Park position with parking lock
R Reverse gear
N Neutral
D Drive
Transmission position and drive
...
Installing a Child Seat with a Tether
A child seat with a tether can be
installed in any seating position in
the back seat, using one of the
anchorage points shown above.
Since a tether can provide additional
security to the la ...