Subaru Legacy: Wiper intermittent time control
When the wiper switch is in the “INT” position, turn the dial to adjust the operating interval of the wiper. The operating interval can be adjusted in five steps from the shortest interval to the longest.
Windshield wipers
MIST : Mist (for a single wipe) OFF : Off INT: Intermittent LO: Low speed HI: High speed To turn the wipers on, push the wiper control lever down. To turn the wipers off, return the lever to t ...Windshield washer
To wash the windshield, pull the wiper control lever toward you. The washer fluid sprays until you release the lever. The wipers operate while you pull the lever. NOTE The windshield washer fl ...See also:
Locking with power door lock switch
To lock all the doors without a key, push the door lock switch (drivers or front
passengers side) to the lock position (1) . When locking the door this way, be certain
not to leave the key insid ...
Cellular and GPS Antennas
Avoid placing items over or near the
antenna to prevent blocking cellular
and GPS signal reception. Cellular
reception is required for OnStar to
send remote signals to the vehicle. ...
Parking Brake
Parking Brake
The vehicle has an Electric Parking
Brake (EPB). The switch for the
EPB is in the center console. The
EPB can always be activated, even
if the ignition is off. To prevent
dr ...