Chrysler 200: Flash-To-Pass
You can signal another vehicle with your headlights by lightly pulling the multifunction lever toward you. This will turn on the high beam headlights until the lever is released.
NOTE:
If the multifunction lever is held in the flash-topass
position for more than 15 seconds, the high beams
will shut off. If this occurs, wait 30 seconds for the next
flash-to-pass operation.
High/Low Beam Switch
Push the multifunction lever away from you to switch the headlights to high beam. Pull the lever toward you, to switch the headlights back to low beam. ...Fog Lights — If Equipped
The front fog light switch is on the multifunction lever. To activate the front fog lights, turn on the parking lights or the low beam headlights and pull out the end of the multifunction leve ...See also:
Moonroof (if equipped)
WARNING
Never let anyone’s hands, arms, head or any objects protrude from the moonroof.
A person could be seriously injured if the vehicle stops suddenly or turns sharply
or if the vehicle is i ...
Vehicle identification plate
Vehicle identification plateVehicle identification number AGross vehicle weight BGross train weight CMaximum front axle weight DMaximum rear axle weight E
The vehicle identification number andmaximum ...
Operating tips
● When the shift selector is shifted to R (Reverse),
the monitor screen automatically
changes to the RearView Monitor mode.
However, the radio can be heard.
● It may take some time unt ...