Subaru Legacy: Displaying satellite radio ID of tuner
When you activate satellite radio, you should have your satellite radio tuner ID ready because each tuner is identified by its unique satellite radio tuner ID.
The satellite radio ID will be needed when you activate satellite radio and receive satellite radio customer support. The satellite radio ID can be found on the audio display by tuning the channel to “000”.
Turn the “TUNE/TRACK/CH” dial to select the satellite radio channel.
NOTE
For Sirius, change the display to an indication mode other than the channel number after performing the above operation.
XMTM satellite radio reception tips for antenna on the windshield (for U.S.A. only — if equipped)
For some models, the satellite radio antenna is fixed to the upper right hand corner of the windshield. The XMTM satellite radio receiver that is fitted to your vehicle receives the necessary s ...Band selection
Press the “SAT” button when the radio is off to turn on the radio. Press the “SAT” button when the radio is on to select SAT1, SAT2 or SAT3 reception. ...See also:
Dialing from a call list
The dialogue below enables you make a call from one of your cell phone's call
lists.
The user initiates the dialogue by saying:
Phone > dial from call list
or
Phone dial from call list
C ...
Uplevel Headlamp Assembly
The uplevel model vehicle has a
high intensity discharge (HID) high/low beam, a dedicated DRL, and a
parking/turn signal lamp on the
headlamp assembly. See High
Intensity Discharge (HID) Light ...
Detachable key blade
Each remote key or PCC contains a detachable metal key blade for mechanically
locking or unlocking the driver's door and the glove compartment, and to enable
the valet locking function. See pa ...